There is few ways of increasing torque inside the transmission. The most obvious one is using a torque converter of which is used to transfer rotating power from a prime mover such as the combustion chamber. Also, you can replace your rear end gears with taller gears.
You have to remove the transmission to replace the torque converter.You have to remove the transmission to replace the torque converter.
The torque converter is located between the engine output shaft and the transmission. Have to drop transmission to remove.
No , just the automatic transmission has a torque converter
It is the part that the torque converter goes into in the transmission.It is the part that the torque converter goes into in the transmission.
The torque converter is between the engine and transmission.The torque converter is between the engine and transmission.
No, a manual transmission uses a clutch. Torque converters are used on automatic transmissions.
The torque converter solenoid is inside the transmission on the valve body.The torque converter solenoid is inside the transmission on the valve body.
In case of Bikes: By increasing the gear ratio from the main transmission point. As the torque and speed ratio is inversely proportional so increasing the teeths of the rear end gear to the main engine gear will increase the torque simultaneously it will also reduce the pick up
In the transmission
the torque converter sets in the bellhousing of the transmission. the very front engine facing part of the transmission that is flared out like a bell.
That depends on the seller of the transmission.
torque to 96-110in/lbs