If you can still see the wire, use pliers and pull, it should release the hood.
if you look up under the hood in front there a little slider that the cable runs to you can slide it and it should pop
you will need to buy a tool to release it, Ecklers sells them my hood release is stuck on the drivers side of a 1985 corvette. how do I get it to release? I there a bypass?
Depends on the car. Some you can reach up behind the bumper and trip the release. If the cable is broken inside, you may be able to reach it as it comes from the latch and pull on the housing enough to release it. Some you can go through the grill and remove the bolts holding the latch to the radiator support.
The latch itself is held on with bolts, easy enough to change. The release cable has to be fed down the inside of the rocker panel and into the trunk.
Have somebody hold the hood release cable in at the handle while you close the hood. If it works, your cable may be over stretched.
You're going to have to pull the latch manually. The best bet is to go through the grille with a special tool or fabricate one out of heavy wire. The cable connects to the driver's side of the latch and pulls it open from there.
If the hood release does not work, the front grill comes off by removing 4-5 small screws. That allows access to the latch so it can be opened by pulling the cable or moving the latch itself. My hood release works when it wants to. It is very moody.
The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.
i have a 1994 pnotiac sunbird that the handle broke off on the cable under the dash to open the hood. you can open the hood with a little patience and a fairly long screwdriver by releasing the latch under the hood. after this, on my sunbird, i just pulled the cable all the way out under the hood, tied it under the front of the car, and just pull it to release the switch. (thats only because i am too cheap and lazy to spend the money and time on a cable and install it.)
use the gas tank to masturbate and ejaculate in the engine
how to get a 2001 isuzu trooper hood open if release cable is broken
dodge truck broken hood latch
The latch is broken, not the cable. You can still get to the cable where it is attached to the latch in the foot-well of the car. Grab the cable with a small vice-grip (or similar) and pull. Note that it is very unlikely the cable will break -the latch typically breaks before the cable since the latch is made from plastic and the cable from steel wire.
If the cable release is broken for the hood on a 2002 Kia Spectra, a person could crawl under the car and see if they can locate the broken part of the cable. If it is still attached to the hood, they could pull it to trip the hood latch. Otherwise, the car will have to be put on a hoist, and a long pole used to trip the hood latch.
From under car... its not too bad on a lift you can find cable near the hood need to get the inner wire and pull with pliers
omg u Have to go thru the grill and pull the release latch
Remove the grill, cut the cable and pull it with a pair of pliers or vice grips. It might even be possible to push the release on the latch manually, after the grill is removed.
you can get to the latch through the grill
If it is just the inside handle broken off you can pull the cable with a pair of pliers. If it is in the middle, you should be able to reach up from underneath and cut the cable and then pull the inside cable. If the latch end has pulled off, you may be able to trip the latch from underneath, or take the grill out and unbolt the latch.