answersLogoWhite
Business & Finance
Home & Garden
Swimming Pools
Skunks
Masonry

How can you remove skunk spray from swimming pool water?


Top Answer
User Avatar
Wiki User
Answered 2009-06-12 07:24:06

Use extra chlorine for about a week to shock the pool. As long as the water stays clear, you don't have a problem. If the pool gets cloudy, consult a professional.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


No. You have to bathe in tomato juice! YUCK!


Scrub with a paste made of a few drops of dish detergent, baking soda, and equal parts of water and hydrogen peroxide. Let set for 3-5 minutes, flush with water.


no its not but it does remove water and repells water


You have to spray LOTS of water on it.


Not exactly. The high winds can, however, spray some water out of a swimming pool. A tornado can also damage the walls of above ground pools, causing water to spill out.


Acrylic paint is water based, so water or soapy water should be used to clean a spray gun.


Remove some of the water and refill it with fresh water.


The strong winds of a microburst may spray or splash some water out of a swimming pool, but other than that, no. Unlike a tornado, air in a microburst does not travel upwards.


To remove rust from the water in a swimming pool, shock the pool until the water is clear of everything other than the rust staining. Then run the filter, backwashing frequently until the rust is gone.


Sand them off when hard and re-spray after warming the can in a sink of very hot water.


To remove coconut water stains, first soak with cold water for a small amount of time. Then, spray the stain with a stain treatment, then wash in cold water.


no, becvaus ethe rats do not like the smell of the skunk as it burns its penis, but the skunk will only spray its stink if it needs a wee, so they can live together, but just dont feed pof give water to either of them, neither should you give them any attention or sunlight, so always keep them up your bumhole


Salt water iscleaned the same way as any water. it is run through filters. this cleans the water as in salt water swimming pool but does not remove the salt. to remove sat you need a desalinater.


Yes The spray from a skunk is caustic. Damage to eyes is often a problem. Wash your dogs eyes out with clean luke warm water ASAP. Rinse any mucus membranes including nostrils and mouth. The spray from a skunk actually is a viscous fluid that sticks to the dog if it has been too close when sprayed. The best way to get rid of skunk smell. 1 bottle of Hydrogen peroxide (available at drug stores) 1/2 cup of baking soda 1 tablespoon of any dish soap Mix this in an open container (it will bubble) decant into a spray bottle Spray on the pets dry fur and leave to soak for 5 minutes NOTE: do not get this solution in your pets eyes, it can burn. Rinse the pet with clean warm water. re-apply the spray solution with a little extra soap and rub into fur Rinse well again and dry pet. This remedy is absolutely the best. It mimics the very expensive spray available from the Vet. and pet supply stores.


Evaporative-cooling. Spray water on the cement and it will be cool too.



The following steps to paint car with Spray : a), Remove the dust with a cloth, then with a soap and water. b), with the help of a Sand Paper remove the old paint. c) Paint with the Primer with two or three coats. d) Spray with the Paint and finish them.


Tomato juice works great, give the dog and or cat a bath in warm water and pour tomato juice on the entire coat, let sit for a few minutes. Might need repeating depending on the severity of the spray. For clothes soak in a sink of tomato juice.


Wash its eyes with water; if it doesn't work, the take it to the vet immediately.


one way of killing velvet mites is to spray a lot of water on one.


Spray the plant with a mixture of 1 part bleach and 8 parts water.


Tomato juice should remove the smell(ketchup won't work)I know from experience that tomato juice is a very ineffective way to remove skunk odor. Here is a better way:1 gallon water1 quart hydrogen peroxide ~3% solution1 cup baking soda1 good squirt of hand or dish soapBut the BEST way is Nature's Miracle found at pet stores and retail stores. It is the best way to remove skunk odor.


To remove mildew from a fiberglass tub, use a mixture of water and white vinegar. You can add this to a spray bottle for easy cleaning.


The only real way to remove mold is to physically remove it. You can try straight bleach to the affected area. That may help get rid of it but not completely.


You can spray it with cooking spray or water. But you'll more than likely to spray it with cooking spray ''', so it couldn't stick to the pan.'''



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.