Want this question answered?
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
Behind left side of Instrument Panel, above the fuse block. I am told you must remove the dash to get to it.
remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights
How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
try a screwdriver
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
The flasher for the 1996 Oldsmobile Delta 88 is located under the dash on the left hand side. Remove the plastic kickpanel that houses the fuse box by removing three screws and one wing nut on the firewall left of the brake petal.the Flasher is clipped on the upper side of that plastic kick panel.
To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.
with a hammer
Remove the instrument panel cover retaining screws. There are four screws that need to be removed. The instrument panel light bulb's will be visible. Push the light bulb in and turn at the same time to remove the light bulb.
Disconnect the negative bat. terminal. Remove the instrument cluster. Remove the hood release cable. Remove the retaining screws and detatch the left and right lower dash panels. Remove the glove compartment and ashtray. Remove the heater control assembly. Remove the center console. Remove the steering column U bracket and lower the column and support it. Remove the defroster grille and the defroster ducts at each end of the instrument panel. Remove the upper and lower panel bolts at each end. Remove the panel frame from the floor bolts in the center. Remove the mounting bolts that attatch the instrument panel to the cowl at the base of the windshield. Pull the instrument panel back and disconnect all electrical fittings. Remove it from the door opening.