Want this question answered?
how do you replace the AC compressor clutch on 2006 liberty
It is probably the throw out bearing going bad. You have to remove the transmission from the bottom to replace it. Replace the clutch, pilot bearing, and throw out bearing and have the flywheel resurfaced.
$126 for the whole clutch kit. Clutch,pressure plate,and throwout bearing.
To replace a throw out bearing in any car or truck you must remove the gearbox, then remove the clutch, then pull the bearing out of the flywheel and replace it. Assemble in reverse order.
Just take the transmission off and the clutch will be exposed. Its that simple. Of course you need to remove the clutch cover, if any fingers are bent or broken, then replace the cover. While your at it replace the release bearing and pilot bearing.
clutch plate disc and throwout bearing
need to replace thrust bearing
Unfortunately, you have to remove the transmission.
yes you can
This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.
There is no way 2 adjust the clutch. The only way is 2 replace them. Clutch & pressure plate & throw out bearing, replace them all in one shot!!
The throwout bearing is bad. This bearing sits in the center of the clutch. Replacing it requires removing the transmission from the car, and it would be a VERY good time to replace both the clutch and the pressure plate while you have it apart.