We need you to answer this question!
If you know the answer to this question, please register to join our limited beta program and start the conversation right now!
How do you replace rear wiper switch on a 2001 Wrangler?
Remove the dash bezel, remove the switch, reverse process with new switch. ...
Asked in Grand Prix GT
How do you replace the heater switch in 2003 Pontiac Grand Prix?
Need a little more info on what your trying to replace. Is it the switch in the dash? It's in the overhead console. ...
Asked in Cars & Vehicles, Ford Bronco
How do I get the dashboard ignition switch out to replace my lost ignition key on my 1979 ford bronco?
There is a lock ring on the inside of the dash where the switch connects. You need to remove this lock ring to remove the switch from the dash. ...
Asked in Car Electronics and Lights, DIY Projects
How do you replace the headlight switch on a Mercedes s500?
Disconnect the negative cable. Remove any screw from the switch. Slide the switch from the dash. Remove the switch and insert the new switch. ...
How do you replace the ignition switch on an older bronco?
How much 'older'? I have a '78 Bronco. Ignition switch has a bezel ring that secures the switch to the dash. Simply unscrew the ring from the front, then pull switch assembly from the rear of dash. Once it is free from dash there are plastic clips holding the assy together. ...
Asked in Fiat Cinquecento
How do you reset the fuel cut off switch for a fiat seicento?
fuel cut off switch is under dash near center console towards bulkhead just press it in and off you go ...
Asked in Chevy S-10, Heater Cores and Blower Fans
How do you replace the heater switch in a 2002 s10 truck?
Pull the front dash bezel out that surrounds the cluster and the radio and the a/c-heater controls out and then remove the controller and replace the switch............. ...
How to replace lights on 2001 impala dash?
If all the dash lights are out, it is the switch that is the problem.other wise, you have to remove all the lowre pannels to get at the bolts that hold the dash cluster in. ...
Asked in Chevy Impala
Where is the flasher found on a 2004 Chevy Impala?
The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike ...
How do you take the dash apart in a 1989 Camry Sedan in order to replace stoplight switch?
do not take dash apart follow brake pedal upward and look for a switch that opens when pedal is depressed that is the sls. ...
Asked in VW New Beetle, DIY Projects
How do you replace the turn signal switch on a new beetle?
To replace the turn signal switch on a new Beetle, the old switch has to be removed and a new one plugged in. The turn signal switch or flasher is located under the dash just above the brake pedal. ...
Asked in Ford F-150
How do you replace the fuel selector switch on a 1990 Ford F150?
Take a small blade pocket screwdriver and slightly insert it between the dash and the switch. It should pry out and you will be able to get to the wiring to remove the old switch and replace the new. ...
Asked in Car Electronics and Lights, Headlights Tail and Brake Lights, Mercury Sable, Ford Aerostar XL
Why do your dash lights not go on until you use the dimmer switch to turn on the dome light on your 1992 sable fuses look ok what else could it be?
The dash light dimmer switch is worn out. You need to replace it.
How do turn off the parking brake light in 1990 Chevy Astro?
When the brakelite switch fails it fails to on. Replace the brakelite switch. Located under the dash on the brake pedal arm. You will see a push switch that is released when the brake is pressed. Just replace that switch. ...
Where is the brake light switch located on a 1987 ford thunderbird?
Under the brake pedal. Looking up at the pedal you will see the switch it is srewed to the dash and rests on the metal arm of the pedal when you press the brake pedal the switch close's and the brake lights come on. To replace the switch it is very straight forward just remove the srew from the dash separate the wire and replace.. ...