0
put car on lift,remove exhaust system,put car in gear and watch driveshaft wobble!
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you tell if CV joint in your Dakota's front drive shaft is bad?
it makes a knocking sound when u turn the wheels.
The 1997 Lincoln mark viii transmission make a noise when i backup?
Typical U-Joint noise. Makes noise in reverse but not in drive. Check both front and rear U-joints of the drive shaft. If one is bad replace both. You do not want to go through R&R of the drive shaft twice.
How do you change fuel pump on a 2001 Lincoln ls?
you remove drive shaft, exhaust, take the fuel tank down, change bad pump (you have 2) and then calibrate ECM since fuel pressure will differ...
Would a bad drive shaft cause car to shake at high speeds?
Yes it will.
If the crank shaft in a 1990 gmc pick up went bad how will the truck drive?
It won't.
What will cause a car to shake in the rear on acceleration?
If it is a rear wheel drive car you could have a bad U joint, bent drive shaft or a broken tooth or two on the ring and pinion gear. If it is a front wheel drive vehicle you may have a bent rear axle or bad bearing. If it is four wheel drive or all wheel drive you may have a bent drive shaft.
What is Grinding in front of 1999 sunfire if wheel bearing is good?
Sounds like you have a bad drive shaft.
Your transmission clunks when you go from park to either drive or reverse you got a 2001 v6 grand am auto?
Usually a bad U Joint - Universal joint connecting drive shaft to transmission & rear drive axle - there is a U joint at each end of the drive shaft - repair this ! Thew drive shaft can actually come off the car when driving - can be very dangerous.
Will your front drive shaft u joints go bad if they are just spinning while your in two wheel drive?
NO. that's wat they are for to let it turn
What can cause a squeaking noise from the drive shaft of a Ford F350 crew cab?
it could be a bad universal joint.
How can you tell if the CV joint on a 2002 Jeep Grand Cherokee is going bad?
I think you mean axle shaft joint. A crunching noise, especially when turning corners suggests bad axle shaft joints.
How do you tell if the slave cylinder is bad?
The shaft seal will leak or not work when the system has been properly bled.
