answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How can you tell if the cv axle needs to be replaced And if you are turning to the right is it your left one that needs to be replaced or right?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2000 Malibu steering clicking noise?

if clicking is in turns than a front axle needs replaced. if turning right it is your left axle-- turning left it is your right axle!! the clicking is the cv joint in axle.


What would cause a grinding noise when turning the steering wheel to the right in a ford transit?

most grinding noises that come from turning is usually a cv axle that needs to be replaced. Can also be a bad wheel bearing. If you hear the grinding when turning to the right then the left front wheel bearing is bad.


1994 Mercury Villager steering pops while turning right?

Sounds like a drive axle half shaft. Have it replaced. Not that expensive.


Your 2005 Chevy makes a noise from the front end only when turning right?

posibly needs a new axle cv is bad


What would cause my 2001 VW Cabrio to shake violently while accelerating?

Your front, left or right axle needs to be replaced.


Why does transmission fluid leak out of the front axle on a 1998 Chevy Malibu?

Axle seal is bad and needs to be replaced


What are the symptoms of bad CV axle?

When turning left or right, you will hear a clicking noise.


Do you have to remove both axles to replace one seal in the front diff on a 1996 dodge 1500?

The right seal can be replaced by only removing the right shaft. To replace the left seal, the entire axle needs disassembled.


How do you replace the inner axle boot - satruen sc1?

Change the entire drive shaft. Chances are, if the boot needs to be replaced, the axle will go out because moisture and dirt has contaminated the CV bearings.


Do you need to make an alignment after you replaced the axle?

If you replaced an axle without touching camber, strut, and tie rod bolts. then no.


Why is 8.8 ford pinion yolk loose on rear axle?

It's wore out, so now it loose and the bearing needs to be replaced O


Did Axle get replaced in inazuma 11?

yas he did get replaced but came back again