0
When can turn the fan freely with no resistense
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
90 Dodge Dakota 4WD auto trans works then just like nothings there?
Possible bad torque converter, low fluid level, bad clutch packs
Why does my 1996 Dodge Dakota squeal when I push in the clutch?
Could be a bad clutch plate, failing throw-out bearing, or other issues. If soon you press the clutch pedal and nothing happens, one of those mentioned is the most likely reason.
How do you tell if oil pump is bad on a 2002 dodge Dakota?
Oil pressure test. If you have a gage it should read around 40 psi when hot.
How can you tell the clutch cable is bad?
You can tell by how much higher the clutch pedal is to the brake pedal. when new pedals are at the same height.
Would a bad o2 sensor cause a 02 dodge Dakota to stall?
Yes, a bad O2 sensor would cause a 2002 Dodge Dakota to stall. It would also cause bad fuel mileage and hard idling within the vehicle.
What makes a 1999 Dodge Dakota sputter?
There are a few things that can cause a 1999 Dodge Dakota to sputter. For example, the battery may be malfunctioning or the park plugs can be going bad.
How do you tell if slav unit that engages clutch is bad?
clutch wont work will also leak fluid
Will a bad belt tensioner on a 94 dodge Dakota tick?
It could.It could.
Should you drive your 94 dodge Dakota truck with a bad water pump?
yes
Can smoke test tell if leak detection pump on 2001 dodge Dakota is bad?
Yes, it can rule out an actual leak as a cause for a fault code and can be used to see if the pump itself is leaking.
How do you correct trouble code p0138 on a 2001 dodge Dakota?
it's the code for bad o2 sensor. i think its the downstream one. take it to autozone and have them check it for free. then they can tell you which o2 is bad. change it and reset the code. good luck.
How do you remove the piolot bearing from a 95 dodge Dakota?
yes you can replace the bearing...but by the time you drop the transmission to get to the bearing, you are better off replacing the clutch, pressure plate and throw out bearing!! so you can avoid taking everything else out later.......because if the bearing is going bad then the clutch and pressure plate probably not far behind!!
