400's are externally balanced, so the balancer is funny looking compared with a 305 or 350 balancer. Has a part of the outside diameter cut away. Also, the ring gear has a balancing weight attached.
Many ways. Pontiac 400 has a cast aluminum timing cover, that mounts the water pump directly on it, Chevy 400 has a stamped steel timing cover, water pump mounts to the block. Pontic 400 has fuel pump on the drivers side, Chevy is on passenger side. Pontiac has a separate valley cover below the intake manifold, Chevy intake IS the valley cover. Pontiac distributor does not go through the intake manifold, Chevy does. Pontiac has 10 head bolts per side, Chevy has 17. Pontiac has long exhaust ports that bend 90 degrees from the side of the cylinder head, Chevy exhaust ports end at the face of the cylinder head. Pontiac spark plugs are above the exhaust manifolds, Chevy is below. Pontiac 400 is physically larger than the small block Chevy 400 also.
The 400 Chevy is a small block engine. The 400 BIG BLOCK Chevy does not exist! 402 big block Chevy does. it seems in the early 70s Chevy put 402s in their pick ups and they had 400 badges. this opened the can of worms known as the non-existant big block 400.
Chrysler 383 is a big block. The Chevy 383, is a de stroked 400, small block.
Are you asking how many freeze plugs are in a small block 400? If you are it varys, could be, 8 could be 10 depending on which casting you have. I hope this answers youre question.
You can if it has the Chevy bolt pattern.
400 ci Chevy, 400 ci Ford, 400 ci Chrysler, need to know which 400.
yes it could have if it was a big block car or someone installed it at one time.
with no problem. you could bolt a 572 in. remember trans will have to be a 4l80e trans. and if its carb just use a turbo 400 trans
A Chevy turbo 400 will bolt up to a Chevy 400 engine just fine. A BOP (Buick, Olds, Pontiac) turbo 400 will not bolt up to a Chevy engine. The bellhousing is different between the Chevy turbo 400 case and the BOP turbo 400 case. Another option is a J-W Performance ultrabell which can be used with a Chevy or a Buick, Olds, Pontiac engine, but this requires the transmission case to be modified in order to use it (The original bellhousing must be cut off and the case prepped, then the ultrabell bolts on with the front pump bolts).
a 400 small block Chevy has a 4.125" bore.
No, I do not think so as they are not the same engine.
Yes it will.