have good supply of new correct brake fluid on hand easiest way to change fluid it to open bleeder valve on brake. fluid will run out die to gravity keep reservoir topped up till new fluid runs out of bleeder, tighten bleeder, make sure reservoir is at correct level, replace cap. do this to both wheels , one at a time .
The answer above is a brief summary of how to do this but for a thorough explanation see the link below
You should use DOT 4 brake fluid for dirt bikes. This is the most common type of brake fluid available on the market.
You push the brake.
Step on the brake pedal? Not sure what you are asking.
Your Honda dirt bike transmission as a capacity of two pints of fluid. The manufacturer recommends that you never overfill the transmission fluid.
You can not change a dirt bike's VIN number. You can change the racing number by contacting the race officials.
how do i fit a clutch on my grizzly 12 dirt bike
A street legal dirt bike is any dirt bike that has a four stroke motor, head lights, brake lights, turning signals, a spark arrestor in the silencer, and street legal on-off road tires.
The red brake light indicates that the parking brake is on or that the brake fluid is low. Be sure to add the specified brake fluid if you add fluid. Also make sure that you don't allow any dirt to get into the brake fluid and don't overfill the brake fluid either.
The fluid line need to be disconnected and the fluid drained. The master cylinder can then be removed and a new one installed. The system will have to be bled to remove any air.
If you want to , you can buy a bottle of the correct type of brake fluid and " top up " the brake fluid reservoir yourself . Just make sure the cap area is wiped clean before removing the cap so no dirt falls in the reservoir . As the brakes wear , the brake fluid level will go down
on what machine? I have a dirt bike and all you do is hold the front brake and lean forward and gas it....
you do not have to have a dirt bike liscense dumbazz