0
How do I remove and clean the EGR Valve on a 1997 Geo Prism 1.6L 4cyl?
Wiki User
∙ 9y ago
Remove the EGR valve vacuum lines. Remove the EGR valve retaining screws. Wash the EGR valve in hot water. Allow the valve to thoroughly dry before installing it.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you replace EGR valve or clean it on 1997 Dodge Avenger?
Replace if failed.
How do you replace an egr valve on a 1997 Acura CL 30?
first buy one from somewhere then remove plastic covers disconnet negative battery cable then remove clamp then remove to bolts rear bolts are a pain in the assss then clean everything
How do you remove valve cover gasket on 1997 Cadillac catera?
i am going to change the valve cover gasket on my 97 cadillac catera, what do i need to remove and do? Is it hard?
How do you take out and install a switch ignition?
my granddaughter has a 1997 GEO prism LSI. i need to know how to remove the ignition switch
Where is the transmission solenoid for 1997 Ford F-150?
Bottom of the valve body. Remove tranny pan to get at it
Just replaced EGR valve on 2001 Malibu Why do you keep getting a code for the valve?
in my exsperience egr valve code not usually the culprit try to clean all intake parts w/carb cleaner fuel inj cleaner may need to check fuel to air mix valve and remove and clean also clean butterfly valve for intake very well if thiis doesnt work repost tom and ill walk u thruogh the rest Tom my question is on 1997 ford exploer the code says insufficent flow to egr valve but replaced everything pertaining to egr system
Where is transmission solenoid on a 1997 4l80e?
The transmission solenoid on a 1997 4l80e is located at the bottom of the valve body. If you want to get to it, you would have to remove the tranny pan.
1997 S10 Blazer 4.3L ruff idle after tuneup?
Clean EGR valve, maybe stuck open with carbon
Where is the fuel filter on 1997 geo prism?
It is located on the driver's side right below the air cleaner. You may have to remove the carbon canister to get it.
How do you replace a Valve cover gasket 1997 dodge neon?
1. Mark your plug wires 1-4 2. Remove your plug wires 3. Take off the 2 to 3 hoses connected to the Valve Cover. 4. Remove the 4 bolts from the coil packs and remove coil packs 5. Remove 6 bolts from Valve cover. 6. Clean up valve cover and make sure no gasket is left over. 7. Put new gasket on and repeat this in reverse for installation. Note: You will have to call Autozone or a local dealership to find out the torque specifications on your valve cover bolts. I usually replace them, but it is not necessary.
How do you remove 1997 sable speedometer sensor?
Is it a 12 valve engine or 24 valve? What do you mean by speedometer sensor? Do you mean Vehicle speed sensor? If so why do you want to change that?
How do you replace the EGR valve on a 1997 maxima?
* Remove the air intake duct from the throttle body and air filter housing * Detach the vacuum line from the EGR valve.Disconnect the EGR pipe nut * Remove the EGR valve mounting fasteners * Remove the EGR valve and gasket from the manifold.Discard the gasket * With a wire wheel buff the exhaust deposits from the EGR valve mounting surface on the manifold
