You go to a parts store and buy a new one or you can buy a rubber patch kit and repair it for temporary use but most parts stores will have a new hose for you and others will have to order it.
The estimated cost to replace a clutch and radiator, in a 1989 Nissan pickup truck is $1100. A private mechanic may be able to do the job for less.
there was no 1989 vigor..acura
The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.
you have to take that bottom radiator hose off to replace it
Replace water pump and gasket
The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.
Drain the radiator. Remove the water pump belt and fan, remove the fan shroud if necessary. Unbolt the pump. Using new gaskets install the new pump. Reinstall the belt and fan then fill the radiator up with new fluid.
If you have a 4-cylinder, about 20 minutes. 90 minutes if you have the V6.
As with all basic engine configurations and designs, the water temperature sensor is usually located inside or with the water pump assembly. To find the water pump, just follow the large diameter?æhose that comes out from the radiator.
The 1989 Toyota Camry water pump is located on the front of the engine. You can follow the top radiator hose directly to the water pump.
The radiator fan switch on a 1989 Jeep Cherokee is located on the driver's side fender wall inside the engine compartment. It is a box about 1inch by 1inch just below the battery location.
The thermostat on a 1989 Chevy Celebrity is located under the water outlet fitting. Follow the upper radiator hose, it will end at the water outlet.