Recently broke exterior door handle (door froze) on my explorer.
I ordered the handle through dealership ($146) then painted the handle. To remove the door panel there are two snap on caps that must be removed first, one on the handle and one next to the latch. Pull off the cap/panels then remove screws plus one screw at very bottom of panel. To get the panel off you need to pull hard in out and upwards direction to get snaps off. There will be a cable that connects to your latch that can be remove with needle nose pliers. Also there is an electric cable with a snap connector. Push in the tab and pull the connector apart.
Cut off the foam backing to access the inside of the door. Remove both nuts holding on handle. Open yellow tab that is on the threaded rod with a pair of pliers (this piece hinges). Remove handle (you may want to remove rod first) replace with new handle and repeat steps in reverse.
replacing door handle on a 2001 ford explorer? what tools are needed?
Its on youtube
how do you replace a left door handle 2002 sport trac ford
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
Should have access after removing inner door panel Should have access after removing inner door panel
To replace interior Ford fusion door handle you must remove the door panel, take off the old handle and replace with the new one, and then replace the panel back on the door frame.
I ran into the same problem with my 99. Turns out the handle is riveted on and has to be done by the dealer. There is a certain tool i guess that is needed. Goodluck
how do I replace the inside door handle on a 1998 chevy cheyenne?
youll need to take the door panel off, then unscrew the handle assembly and replace with a new handle ( junkyard?). screw that in then replace door panel.
I have to replace the drivers side door handle on a 2006 Buick Lucerne. How do I remove the panel to access the bolts on the handle. (Like most panels there isn't visible screws to remove the panel.
Inside door handle or outside door handle?
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.