Cars & Vehicles
Pontiac Bonneville
Ford Expedition XLT
DIY Projects

How do You remove a door panel on a 1998 Pontiac Bonneville?

Be the first to answer!


Be the first to answer!

Who doesn't love being #1?

Be the first to answer this question.

Related Questions

Before you remove the evaporator core from a 1998 Pontiac Bonneville you need to have the air pressure discharged. You will then need to remove the AC unit. You will need to remove some screws before you can remove the evaporator.

How do you replace passenger side fender on a 1998 pontiac bonneville se

how do i restate my security system in my 2000 Bonneville

On the other side of the tail lights, inside the trunk fastened with plastic nobs, pull back trunk trim panel.

Very difficult and too lengthy to explain here. You need to get a manual for the vehicle and follow directions.

To remove the evaporator core on a 1998 Pontiac Bonneville, you will need to remove the dashboard. An alternative method is to access the core underneath the hood. The core can be found at the passenger side near the strut tower. Once the area is accessed, you will need to remove some of the firewall to properly remove the core.

Check under plastic panel just forward of wipers with hood open. Should say relay center or something like that. A couple of clips and a wing nut to remove cover if I remember correctly.

under the hood. its the thing that looks like an alternator.

The firing order for a 1998 Pontiac Bonneville 3.8 SE is 1, 6, 5, 4, 3, 2. This engine has the number one cylinder on the right side, in front of the passengers seat.

1985 Pontiac bonneville,1998 Ford Wind star

to remove pump on 1997 Bonneville, I aligned holes on actual pulley wheel access holes and reversed bolts.........

could be one of the coil packs went bad

You have to remove the motor mount. Once the motor mount is removed you can remove the old water pump and install the new one. Make sure the area is clean before you install the new one.

I have a 1998 bonneville. It does the same thing. Now i have to fill it like every 200 miles or so.

Take the pump with you to an auto parts store so they can fix you up will a puller. Some places will let you "rent, borrow" these specialized tools.

Look along the frame rail or in front of fuel tank--follow fuel lines

take the plastic cover off and you'll fin it under the throttle body

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.