1. Move the driver's seat forward, and locate the security system control unit mounted on the underneath the seat.
2. Turn on ignition switch on.
3. Press and hold the green programming button on the control unit with a pen. you will have to poke through a hole about the size of a pencil located on the side of the unit. when the security system LED on the instrument panel comes on, release the program button, (Step 3 and 4 must be done within 5 seconds of each other.)
4. Press and release the top button on the transmitter, check that the LED goes out chirps once, and the front marker lights flash to confirm that the transmitter's code worked by the control unit.
5. if you have other transmitters to program, repeat steps 3 and 4.
6. Turn the ignition switch off to exit the programming mode.
Where is my filter for my 97 ISUZU RODEO
hoew do you remove a c v axle from a 97 isuzu rodeo front right
what type of transmission fluid used for a 97 Isuzu rodeo
6.0 for the 3.2 liter
yes they were made with the same engine
u have to add and tighten them down
The front transmission line leaks, how do I replace it?
goto www.ecoustics.com I found one for 96-97 for my rodeo on there!! Good luck the colors aren't right
you dont
No. The isuzu trooper 3.5 will work with a 98-2005 rodeo but a 97 is a first gen. The 3.5 is the bored stroked version of the 3.2 with all the same connections as the 2nd gen Rodeos. The 1st gen Rodeos used a different 3.2 with different connections.
It should tell you the size of your engine under the hood once you lift hood up look under it should be a sticker or something I have a 97 Isuzu rodeo it has a 3.2 v6 3.5 were not used in a rodeo.
It means the Anti Lock Brake system isn't working properly