answersLogoWhite

0


Best Answer

i have a 95 ranger, im not sure how different the 2 are, but if u take out the radio and look inside the and to the left you should see a small black box that's the buzzer just unplug it and it and that works but in my truck it also disables all the dash lights and the dome light so i just popped the door panel off and cut the wire. well i hope that helps

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do i disable the door chime on a 2002 ford ranger?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you disable door chime on 1999 F250?

if you have the owner book that came with the vehicle, you can find in the book how to disable the door chime


How do you disable a door chime on a 2000 F250?

The door chime on a 2000 Ford F250 can be disabled by removing the fuse or pulling the wiring harness. The chime is automatically trigger each time the door is opened or is left open


How do you disable a door chime on a 1998 Mustang?

The only thing I can think of is to glue the button in the door jamb.


Were is the door chime sensor located on a 1996 Ford Ranger?

The door chime switch on a 96 ranger is part of the door latch mechanism. If your door chimes all the time when your driving try spray lube on the latch that should free it up.


Where is the door chime located on a 2000 Ford Ranger?

The brain that holds the door chime is behind the factory stereo on the left hand side The brain that holds the door chime is behind the factory stereo on the left hand side


95 Ford Ranger XLT disconnect the chime?

Is your chime continuing after cranking vehicle and door is closed. If so, there is an electrical switch in the door that gets stuck. Use a spray lubricant inside the door latch to free switch.


How do I leave my door open with the radio on without that annoying chime how do you disable the door chime on a 2002 Jeep Liberty you?

Turn the key to ON instead of to auxiliary, the radio will play and you don't have to worry about fuses or the door switch. == == Look in the fuse box and remove the fuse for that particular warning. Be sure the fuse is only for that one though as you may disable another feather in the process. When it's chiming, find the chime and unplug it. Done deal. Pull the fuse or make a device to slide over the door switch when the door is open. A simple piece of metal screwed next to the switch that you can slide over the switch, thus holding it in will work.


How can you disable the door chime on a 2008 Chevy 5500?

MUST REPLACE FACTORY CD PLAYER OR CUT OUT THE SPEAKER LEAD.


Can you disable the warning chime when you open the door with the key in the ignition on a 97 crown vic?

You can unplug it. Its under the dash board


How do you disable a factory alarm system for a ford ranger?

To disable the factory alarm system on a Ford Ranger, you would have to disconnect the remote entry module (REM). However, if you do that, the keyless remote and driver's door keypad will no longer work.


How do you locate the door sensor that controls the overhead light in the cab of a 1998 Ford Ranger?

The sensor is intergrated into the door latch. If it is not working (and the door chime stays on) spray it with WD 40. This almost always works.


How do you disable the seat belt warning chime on a 2004 ford expedition?

I was told that in the Expedition 2004 you can push the belt release button when the chime is going off and that stops it until the door is opened the engine is turned off. Good Luck