I got an MPV 2000, also had challenges identifying where the engine number is. Had to call in a mech, but you can DIY, you can read the engine number from beneath the engine not too far from the oil filter, or somewhere very close, cos the mech didnt have any problem locating it, got the engine number out in a minute.
where the engine number is located it will have FE for 2000 and F2 for 2200
No.
The 2.5 litre V6 engine in a 2000 Mazda MPV has timing CHAINS
yes all the dx lx and es proteges have the same engine. atleast that year does
a Mazda millenia with a miller cycl engine 2.3 engine has 6 igition coils
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
A diagram of a 2000 Mazda Protege engine is available through service repair manuals. The manuals are available in either print or PDF form.
The 2000 Mazda IAT sensor can be found on the back of the engine. The IAT sensor will be just above the bell housing.
Yes, you can if the trans is disconnected.
In my experience ilook in the hood for a stikerand it may be .039 to .043inchesbecause i have 1993 probe and it has the same engine as Mazda 626 engine (Mazda is owned by ford)so parts are same and they will fit any engine _2.0l or 2.5AnswerThe proper gap for a 2000 Mazda 626 would be between .039 and .043-inch.
crawl under your car and look in the rear of the engine.
At the engine end of the upper rad hose.