Always remember to wear safety glasses when working on a vehicle, and wear protective clothing like work gloves and close-toed shoes.
First, remove the front wheel well liners from the front bumper. This will enable you to access the bumper retaining bolts. Take the new bumper cover and make sure it is primed before the paint is applied. Clean the entire bumper cover with wet sandpaper to remove any contaminants or other imperfections. Apply a basecoat to the entire bumper cover, and let the paint dry completely. Apply a clear coat to the entire bumper cover next, and then take a few minutes to check for dirt in the paint. If any dirt has found its way into the paint, remove any large dirt with a sharp razor blade. Soak some 1500 grit sandpaper in soapy water, and add some of the soapy water to a spray bottle. Spray the water on the painted surface. Use a sandpaper block to evenly apply pretty when sanding, and sand the area in a circular motion until the dirt is removed. Repeat this sanding process with 2000 grit sandpaper soaked in soapy water. Wipe the cover down next with an alcohol water mixture, and take some more time to inspect for dirt. Use a polish compound to remove any swirl marks from the sanding, and reinstall the bumper cover.
The lamp in the top brake light of a Toyota Highlander can be replaced by the locating the light housing from the trunk. Find the light cover and remove it to access the lights. Replace the bulbs.
Hi, I was looking for instructions as to "How to replace 1998 Toyota Camry rear bumper cover" and you got your question. If you have already replaced then please let me know otherwise I'm going to replace the part this weekened and I will let you know. Take care, Sam
if the bumper protector is damaged yes, or else the cover will have no suppot
about $1000+/- $100 for bumper cover, labor to r/r and paint it from two reliable body shops. Shocking.Added: In the SE area of the US the above is a good round estimate. Had to have this done to mine about 4 months ago. The cost can actually be increased by the necessity to repair or replace any of the associated mounting hardware, and the need to color-match the bumper to the body paint.
Lower the glove box down remove the plastic cover on the heater box and pull out the cabin filter tray.
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
how much will it cost to replace rear bumper cover on 2003 93 saab
The average cost for the part to replace the rear bumper cover on an Oldsmobile Intrigue varies between $88.00 and $124.00, depending on the year. The labor cost to replace the rear bumper will vary between $75.00 and $150.00 depending on the repair shop.
Very carefullyJimmy out!
The rear bumper cover is held onto the frame by 4 bolts. They have a 13 mm head, and are accessed from under the van. They thread directly into the back of the bumper cover, therefore no nuts to worry about. The rounded edges of the bumper cover slide over a pin, so when the 4 bolts are removed, the bumper cover can be pulled straight off.
Very carefuly.
how to replace valve cover gasket toyota rav4 2001