0
How do remove the harmonic balancer on a 1996 ford ranger xlt 2.3?
Wiki User
∙ 9y ago
After removing the bolt, use a large gear puller. Tighten the puller, tap the head with a hammer, then tighten again. After a few repetitions the balancer will break free.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is harmonic balancer in 1996 Olds eighty-eight?
The harmonic balancer is located on the front of the crankshaft
How do you remove the harmonic balancer on a 1996 dodge neon?
loosen the center bolt and get your self a harmonic balancer puller just make sure you loosen the center bolt enough but not too much but you need a balancer puller.
How do you Remove a Harmonic Balancer on 1996 Chevrolet carprice classic?
You will need a harmonic balancer puller. Remove crankshaft bolt and washer, reinstall bolt without the washer approximately 10 turns. This will protect the threads in the crankshaft. Install puller and remove balancer. You cannot remove the balancer without this puller. They are inexpensive or try to borrow one.
Where is the Harmonic Balancer on 1996 Toyota Corolla?
On any motor, the harmonic balancer is on the front of the crankshaft. It is what the pulley is bolted to.
Where is the crankshaft sensor on a 1996 Buick 3.8 liter Regal?
It is located behind the harmonic balancer on the front of the engine. You'll need a special puller to remove the balancer.
Which direction do you turn the harmonic balancer bolt on a 1996 Sebring 2.5L engine to remove it?
You turn it counter clockwise to loosen.
How do you remove the harmonic balancer on a 1996 Dodge Intrepid?
Hi The 3.5L has a tapered shaft, you MUST use a balancer puller or you will damage the pulley. These pullers are under $30 bucks
Can you put a 1996 Dodge caravan harmonic balancer in a 2002 Dodge stratus?
No
What would cause an engine vibration when in drive at a stop light on a 1996 Ford Contour 2-liter Zetec with automatic transmission?
check harmonic balancer. check harmonic balancer.
Is 400.00 a fair price to have a harmonic balancer orderded and placed in a 1996 Nissan Sentra?
no its not i paid 50.00 dollars for balancer and put it in about one hour
How do you apply the puller to the harmonic balance there are no bolt holes for the outside of the balancer for a 1996 ford ranger?
That balancer requires a 3-jaw puller to pull it off, just be sure you have the claws on straight, and if it gets too tight to turn the end of the puller, tap on the end with a hammer, then turn some more.
Where is the crank position sensor located on a 1996 Toyota corolla 1.6L?
On the harmonic balancer that's attached to the front of the cranck shaft
