0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove front sprocket on 1996 polaris magnum 6x6 at What holds the inner axle in?
YOu need to remove both CV joints. after that the shaft on which the front sprocket rides will come out of the front diff. Just hit it back with a rubber mallet and put your new sprocket in place then hit from the other side to run the shaft through the sprocket. Reassemble. The front 'axle' or diff is held in by the chassis metal being bent around it. it is not removable.
When your in low gear what sprocket are you using?
It depends on whether you are talking about the front sprocket (the one at the pedals, called a chainring) or the sprocket at the rear derailleur. The lowest gear at the front is the smallest sprocket/chainring. The lowest gear at the rear is the largest sprocket. So if you combine the smallest sprocket at the front with the largest sprocket in the rear you have the lowest gear available on your bike.
How do you remove the front sprocket from your Honda TRX 250R ATV?
How do you remove the front sprocket from Honda trx 250r
Where is the oil pump on a 2004 Chrysler PT Cruiser?
Under the timing belt sprocket, on the front of the crankshaft.Under the timing belt sprocket, on the front of the crankshaft.
What is the drive chain size for 2003 Honda Shadow Spirit 750 motorcycle?
with a standard 17t front sprocket and a 42t rear sprocket the standard chain size is a 525 ( x-ring or O-ring) 124 link.
Does a bigger sprocket give higher top speed?
A bigger front sprocket gives a higher top speed. A bigger rear sprocket gives a lower top speed. A bigger front sprocket is less torque more top speed, and a bigger rear sprocket is more torque less top speed.
How do you work out sprocket sizes for bmx?
Divide your rear sprocket into your front sprocket. Like 25x9. 25 divided by 9 = 2.77. so 2.77 to 1 is the drive ratio. If you go with a smaller sprocket like a 24 in the front but still a 9 in the back, you are lowering the gear ratio to 2.66 to 1. So your bike will be slower but easier to pedal. If you go with a 25 in the front and a 10 in the back, you end up with a 2.5 to 1 ratio. Don't confuse gear ratio with gear inches, that's a calculation including the wheel and sometimes the circumference of the tire.
What are teeth on bmx?
In the drive train you have the front chainwheel/ring and the rear sprocket that both engage the chain. The pointy bits on sprocket and chainwheel which allows the chain to grip are called teeth. The ratio between the tooth counts is what determines which gear ratio the bike has.
What size front sprocket would go fastest with a thirty tooth rear sprocket?
No way of telling, it depends on how strong or high revving the engine is. Switching to a bigger front sprocket might make the bike faster, but only if the engine is strong enough.
What are the torque settings for the front sprocket on a bandit 600?
115nm
What is that suppose to mean on a 1998 CBR 600 The bike is geared one tooth down in the front and up two teeth on the rear?
The front sprocket on the engine that the drive chain goes round has approx 16 teeth. To drop it down you remove the sprocket and replace it with a 15 tooth. same idea on the back but up 2 teeth which makes the sprocket larger. Reducing the size of the front and increasing the rear will improve acceleration but will have slower top end, usually makes for better low speed handling too.
What size sprocket is on the rear of a suzuki bandit 1200s?
The chain is size 530, and the stock gearing is 15/45, meaning that the front sprocket has 15 teeth and the rear sprocket has 45 teeth.
