Take out the Tail light,should be a screw at the top. Remove screw pull from the top. Unscrew bulb from the tail light and replace bulb. This is a .5 on a scale of 10 for difficulty
Basically, there are three bolts that you need to take out. Then you pull off the tailight assembly. Replace the bulb as required and then replace the taillight on the car ncmuding any bolts you removed. Refer to your owner's manual.
To change the tail light bulbs in a 1989 Celebrity sedan: 1. Inside the trunk near the quarter panel are 3 nuts. Remove the middle nut, it should be in the center of the tail light fixture. 2. Pull back on the tail light fixture so the stud clears the body. 3. Pull outward on the tail light fixture to clear a tab out of the backup light assembly. 4. Twist the appropriate socket counter clockwise to remove the socket from the tail light assembly. 5. Change the bulb and put the socket back in the tail light fixture. Reverse the removal process to reinstall the tail light fixture onto the car.
The Mazda 5 does not have glow plugs. Maybe you meant spark plugs?
How do you change the battery in mazda 5 key?
Open Hood. Open the hood of your Mazda 5. The hood release is located under the dashboard of your 5.
Between 4-5 quarts of oil.
If its the same as th 1986 version here goes... from the inside of the trunk, you'll see large screw caps. at the location of the tail light assembly. (they are actually a type of nut) These can be undone by hand. Once you have removed them (3-5 total) you will bw able -from the ouside of car- to remove the tail light housing and replace the bulbs
First, open the gate to the truck box. There will be 2 screws that need to be taken out for each tail light, located where the truck box gate latch catches the sides of the truck box on each side of the vehicle and about 5 inches below the latch connection. After removing the 4 screws, the tail light covers can be removed by gently pulling toward the back of the vehicle. The tail light covers are connected to the truck, so be careful not to break any connections or wires. When the tail lights covers are loose, twist to unlock each tail light housing from the tail light cover. Pull out the tail light from its socket, replace with a new bulb, lock the tail light housing and socket in to the tail light cover. Finally, put the tail light cover back into place and replace both of the screws which secure the tail light cover into its housing.
open the trunk, on the side by the opening you will see a round cover, pull that cover back, that will give you access to the screw that removes the tail light assembly. remove the tail light assembly, when you pull out the tail light assembly you will have access to all of the bulbs in the tail light. this is a 5 minute job, very easy.
Pop the trunk, pull back the trunk liner, remove the 5 plastic screws/wingnuts, and separate light assembly from the car, remove the bulbs and replace.
On most American cars, the dash fuse feeds off the tail light fuse. The tail light fuse is typically 20 amps and the dash fuse feeds off from it and is usually 5 amps. If the tail light fuse blows, you loose the dash lights.