It would have helped a lot if you specified what exactly, rather than just 'glue' - there are many different kinds with different solvents. However, try Goof Off, that will soften many glues. Rub with a rag dipped in this and it may soften enough to peel off. Other wise, scraping with a piece of hardwood shaped like chisel may get it off too.
Rub it with Goof Off.
Rub it with Goof Off .
Acetone is an effective remover of most adhesives and I used it to get gorilla glue off 2 pieces of regular steel, worked great.
You can always try melting it with a small flame, or bigger depending on how much there is. But be careful!
Hi, i have a W reg Renault Megane and recently had to put a new door on. I had to remove the interior from the old door and put it on the new door. To remove the interior from the door you need to remove all the screws (including from behind the speaker cover). Once this is done the door card will not budge. The whole door card is glued on with an incredibly strong adhesive. I used a hacksaw blade to gently remove the glue. The glue is only on the bottom half of the door card. Make sure you are incredibly careful when removing the glue because you need to prise the plastics back slighly to gain access to the glue. Good luck it took me ages. I found after unscrewing all observable screws I still could not prise the door off, a friend pointed out that the door handle (used to close the door not door lever to open it) needed to have the cover removed as there were another two screws under there. I did not find the glue a problem as it was quite worn.
You can glue steel. De-grease it thoroughly first with gas or lacquer thinner, then use J B Weld.
Warm water and a little scrubbing can remove white glue or school glue.
peel them off and carefully use wd-40 to clean away any glue left behind
Isopropyl will remove only elmers glue from plastic, not super glue. once it gets on there, you can't remove it.
You might try a hair dryer , sometimes being warmed up will release the glue better.
use wood glue
You have to take the whole door paneling off. then there are 3 screws to undo. then with a knife cut the glue inbetween the door frame and window frame. after a lot of hard work cutting the glue out it will eventually come out