...remove brake drum, shoe and parking brake attachment... remove springs with special brake spring removal/installation tool... you may need new drums or resurfacing.., also new drum brake hardware (i.e. springs)... when you have all the springs off you can see the wheel cylinder on the north portion of the back drum.., remove it by first loosening the brake fitting to the cylinder using a 7/16" Flare Nut Wrench... then remove the cylinder mounting bolts located on both sides of the bleeder screw... reinstall... make sure to spray brakes with brake cleaner before and after service... Enjoy! (you may also want to invest in a large SOFT hammer to get the drums off)
The 4 cylinder in a 1993 Ford Ranger is 2.3 liter ( 140 cubic inches )
you just need to hone it out and replace parts with rebuild kit.
what tools do i need to remove the wheel cylinder on a 1993 pontiac bonneville
Yes , the 2.3 liter 4 cylinder in a 1993 Ford Ranger is a non-interference engine
Remove fitting at junction block (usually at center of rear axle) and disconnect at the wheel cylinder Replace line and bleed air from that wheel. Should only have to bleed that line
I have a '93 Ford Explorer and it hold 19 gallons From the Chilton Ford Ranger guide: "1993 Ranger with standard wheelbase: 16.3 1993 Ranger with long wheelbase: 19.6"
According to www.fuel economy . gov ( no spaces ) The 1993 Ford Ranger with a 2.3 L four cylinder engine and 5 speed manual gets : 2 wheel drive - ( 20 mpg city / 26 mpg highway ) 4x4 - ( 19 mpg city / 24 mpg highway )
how to replace the slave cylinder on a 1993 jeep wrangler
An easy way to do it is to put some wheel bearing grease in the palm of your hand and then, scoop up the grease with the end of the wheel bearing. You will see the excess grease come out from between the bearings. There's an instructional video included below also, that shows how to replace these on a 93-97 Ford Ranger.
Front wheel bearings on a 4 wheel drive Explorer are not serviceable, replace them.
I believe that is inside the manual transmission bell housing
remove the two screws holding face plate in center of steering wheel and remove plate. next remove large nut in center. Using a steering wheel puller remove steering wheel. next there is a pin next tothe lock cylinder. that will have to be driven inwith a hammer and a punch. lock cylinder should be able to be pulled out. installation is the reverse of removal.