1. Turn ignition switch
to "ON" position
2. Set odometer/trip display to "ODO" mode
3. Turn ignition switch to "OFF" position
4. Depress and hold the Trip Meter "RESET" button while turning the ignition switch to the "ON" position
5. The service maintenance reminder light will:
i. Illuminate solidly for 3 seconds
ii. Blink for 2 seconds
iii. Illuminate solidly for 1 second
iv. Turn off
6. Release the Trip Meter "RESET" button
7. Turn the ignition switch to the "OFF" position
8. Turn the ignition to the "ON" position and confirm that the service maintenance reminder light goes out.
How do you reset maint read light on 2010 corolla
The answer is in the manual.
The maintenance required light requires a scan tool to be reset.
read your owners manual
Just found out that it must be reset at the dealership with a diagnostic computer
Unplug or replace maint. timer
Hold trip reset button down then turn key on but do not crank engine over light maint. light will go off after a couple of second.
Maint. required light want reset.
With the key in the off position, press and hold the mileage reset button. Continue to hold the button in, and turn the key into the accessory position. Hold button in until 'Maint Req'd' light goes out (about 5-10 seconds).
The manual says push the trip odometer button with the actual mileage showing and turn the engine to the on position (without starting it) and it will reset HOWEVER it doesn't work... someone told me the 5.7 litre engine is a Lexus. I did the same thing with the trip odometer set to TRIP A (as required for the Lexus) an it reset instantly... good luck. Took me an hour to figure this one out. Hope it helps you.
To reset the maintenance required light on a 1989 Dodge D50, disconnect the battery. Leave it disconnected for 10 minutes before reconnecting it.
A person can reset the maintenance required light on a 2004 Toyota Sienna by holding down the odometer trip button. A series of zeroes will appear, which indicates that the light has been reset.