0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the hold button on a 1999 Kia Sportage on the gear shifter?
holds it in that perticular gear.
Why won't 1996 sportage 4x4 shift into high gear?
Button on side of gear shifter is pushed in!
What does it means when the HOLD light comes on a 2002 Kia Sportage?
Check that the overdrive button on the gear shifter is not disengaged that will cause it to come on.
Why wont your 1995 cavalier shift out of first gear The clutch feels fine but the shifter is sloppy .?
if you have some recent work done i would check to see if the shifter handle was bolted back one correctly,
Why would the shifter not shift out of first gear on a 1997 Dodge Avenger ES?
It is probably a linkage problem
What is the inside of a gear shifter for a 2004 Lincoln aviator called?
shifter rod gear linkage
How do you tighten the gear shifter in an 88 Mazda rx7?
Usually if your stick is sloppy it is due to the plastic bushes being worn out ! They aren't expensive to replace ($30aud) and basic to fit from inside the car
Your Dodge Intrepid shifter cable problems The gear shifter just goes up and dowm without going into gear. What can i do to make it go into gear?
your shifter linkage is probably broken.
How do you use overdrive on 1999 Plymouth Voyager?
Just put the gear shifter into od and go.Just put the gear shifter into od and go.
How do you change the gear shifter on a Volvo 240 gl where do you unscrew it?
The gear shifter has a retaining clip, just below the shifter knob. Hold the retaining clip in, on both sides of the shifter rod, and the shifter knob will come off.
What does it mean when the hold light comes on in a kia sportage 1997?
The button on the side of gear shift has been depressed! This holds transmission in lower gear and should not be used under normal driving!
Shifter sloppy 1995 mercury grand marquis won't go into any gear?
I was not aware that the Grand Marquis came in a manual Transmission! If it was an Automatic Transmission I would say take it to a Transmission Shop and have it looked at.
