The brake fluid is contained in a translucent reservoir with a black cap on the driver's side firewall. To add brake fluid, remove the cap and fill to the appropriate level on the dipstick indicator.
I have found that its a bit easier if you let the pressure out of the brake lines. BUT if you do that make sure you bleed your brakes and add brake fluid afterward
Good question. At the brake fluid resovoir
ADD BRAKE FLUID
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
you should be able to just stick a funnel into the top of the dipstick (transmission) and add the fluid through there you cant just anwer that question assuming its a automatic... if its a 5 speed there is a fill plug in the front of the tranny
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.
master cylinder holds the brake fluid,open it up and add brake fluid to the tank. Make sure you use NEW brake fluid and one that has not been laying around in someones trunk. Remember this what stops your car. Contaminated fluid is very bad for you and your brakes. Usually the master cylinder tank is white in color and sits on the master cylinder itself.
Brake fluid reservoir is located on the firewall next to the steering column. Remove cover top of master cylinder to add brake fluid.
It does not make a difference if the car is hot or cold when you add brake fluid.
The red brake light indicates that the parking brake is on or that the brake fluid is low. Be sure to add the specified brake fluid if you add fluid. Also make sure that you don't allow any dirt to get into the brake fluid and don't overfill the brake fluid either.
Time to add dome brake fluid.