0
What else can I help you with?
Where is the fuel pump on a 2002 GMC serria?
Mounted on top and inside the fuel tank.
How do you adjust parking brake handle on a 2002 sunfire?
Remove rear wheels, remove rear drums, the adjusters are located at the 6-oclock position of the backing plate. Adjust as necessary.
How do you adjust parking brake on 2002 Chevy Tahoe?
do you have 4 wheel disc !!! if so look on the backing plate of the rear axel it adjusts like drum brakes through a hole in the plate
How do you change the clutch and pressure plate on 2002 2500 Dodge pickup?
Hire a professional mechanic, or buy a repair manual.
How do you install a drive belt on a 2002 gmc Serria?
drive belt for what on this vehicle? do u mean serpentine belt,or fan belt,or timing belt?
Where is the oil pressure sensor located on a 2002 Volkswagen Passat?
It's located near the oil filter and on oil cooler/filter plate.
How do you a clutch in a 2002 Kia Sportage 4x4?
The transmission must be separated from the engine, related brackets and lines have to be removed. Loosen the bolts around the pressure plate, the clutch disc will loosen at that time. Be careful as you remove the pressure plate, the disc will fall freely. Use a clutch alignment tool to align the new clutch disc, tighten the pressure plate bolts to specs and re-install the transmission.
How do you adjust GMC Denali headlights?
how do you adjust 2002 Denali headlights
How do you Adjust parking brake on 2002 cadiliac escalade ext?
How do you adjust parking brake on 2002 cadiliac escapade ext
How do you adjust the idal on a Toyota van?
how do you adjust the idle on a 2002 toyota van
Do 2002 Ford Focus have 2 lights on license plate?
yes 2002 Ford Focus do have 2 lights on license plate
How do you change the clutch on a 2002 Yamaha 660 raptor?
To change the clutch on a 2002 Yamaha 660 Raptor, start by removing the clutch cover bolts and taking off the cover. Disconnect the clutch cable from the lever and remove the pressure plate by unscrewing the bolts. Take out the old clutch plates and replace them with new ones, ensuring they are properly aligned. Reassemble by reversing the steps, making sure to adjust the clutch cable for proper tension.
