there is a special screw above the headlamp to do this
See below for instructions.
I think there is a plastic shroud covering the top of those headlamps. If you unscrew the plastic piece above the lamps you should see the adjusment screws The headlamps will only adjust vertical. When you open the hood and look down at the headlamp you will see one small bolt at the bottom corner of the lamp. Turn this to adjust the headlamps vertically. There is NO plastic piece to remove.
Should be phillip's head screws that adjust the left/right and up/down for the headlight. They would be on the inner side of the lamp and top side.
take the bumper and grill, there are app. 5 screws to adjust it with... park on level ground about 20 ft from a wall so so can use the wall to aim them
The population of Forenza is 2,544.
The area of Forenza is 115 square kilometers.
You could try the stick on correctors that the continentals use. But for UK reg/MOT you will need to convert
for how long is the transmission on a Suzuki Forenza 2008
Suzuki produced the Forenza for only five years. The Forenza was introduced in 2004. The last year of production was 2008, therefore the most recent model would be a 2008 Forenza.
There should be two screws, one above and another next to the bulb itself to tilt it vertically and horizontally. Some use Phillips screws while others use Torx. Screwing them in or out adjusts the angle of the bulb.
There is a small screw located on the corner of each headlight. When you open the hood of your car you will see them. Just take a screwdriver and adjust them to where you need them. I have found that parking on the side of the road in front of my house after dark is the best way to adjust them. You can see exactly how far out your beam goes and adjust it accordingly. It's a good flat surface. Hope this helps you.