answersLogoWhite

0


Best Answer

I own a 1989 Dodge Dakota and it has torsion bars that can be raised and lowered. Just follow the torsion bars from the front to the back and look at where they stop there should be a 7/8 bolt that you can turn clockwise to raise the truck and counter clockwise to lower it

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you adjust stock torsion keys on dodge truck suspension?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the difference between dodge stock torsion keys and adjustable lift keys?

stock torsions are non adjustable, the adjustable ones you can adjust to your ride hight ....which lifts the front end for bigger tires..back always has that for bigger tires ..front doesnt..


Can you adjust the ride height of a stock 1996 740IL?

No you can not, at least not with the original or OEM suspension.


How do you adjust valve timing in 97 318 dodge ram?

Valve timing is not adjustable on a stock engine. The timing chain is either installer correctly or not.


Could a 1974 Dodge Challenger outrun a 2010 Chevy Camaro?

Stock for stock... no. Even if the engines matched up as far as horsepower, the technology on the 2010 is just too great. Suspension, rear end, etc.


What size of tires will fit a 2000 dodge Dakota?

stock tires should be either 15x7 or 15x8 the wheel lug patter is a 6x4.5, to accept bigger tires u might consider raising the torsion bars and having it realigned, this is to adjust the front to be raised equal to the back, if u look while its on level ground u will notice the back is prbly higher


1993 dodge shadow stock in reverce?

1993 Dodge Shadow stock in reverce.


How much horsepower and torque does a 2005 dodge cummins have stock?

the 2005 Dodge Cummins stock horsepower is 325


Will 33 inch tires fit stock chev cheyenne with 16 rims?

depends. i have a 93 Chevy cheyenne half ton 4x4 with oversized tires. if you have a 4x4 they'll prolly fit but you might have to crank your torsion bars up in the front. if you have a 2wd then they most likely wont because the suspension sits lower in the front and you cant crank torsion bars on them. id go with 31's if anything because if you mud with the truck they wont hit or rub much at all and they still look nice with the torsion bars cranked a little.


Which stock option is represented by acronym DODGX?

Dodge & Cox Stock fund is represented by the acronym DODGX. Dodge & Cox Stock fund is an American based stock fund and was founded in November 1930 by Van Duyn Dodge and E. Morris Cox.


Did 2000 Dodge Neon come with a stock block heater?

No, it was not stock.


What is the spring rate in PSI for the stock suspension springs on a Datsun 240Z?

The calculated rate in pounds per inch for the stock front springs on a 1971 240z is ~100 lb/in. The data used was from direct measurement as follows: 8 active coils 0.437 inch coil diameter 4.447 inches spring outside diameter torsion modulus (G) 11.5 x 10E06 psi


How do you set the time on the stock radio of a 2005 Dodge Stratus?

There are 2 little buttons on the radio display one for the hour and one for the minute that you have to press with a pin or something sharp of some sort to adjust the time.