There is an idle set screw located on the throttle body just above the air inlet. It is usually covered by gray paint and must be cleaned for the flat blade screwdriver to fit in it. The procedure is as this: With the car running, open (turn counter clockwise) the screw a few revolutions but don't completely remove it. Then with the idle air control motor (located on back of intake manifold next to the throttle body with its 2-wire connector on the underside) unplugged turn the screw back in until the motor comes close to dying then plug the motor back in. Good Luck
i have a 92 Honda civic si... it goes like 102... fully stock..
What is the spark plug gap for a 1992 honda civic. .
Yeah, it will fit. But the 1991 civic sohc 1.5 transmission is cable and the 1992-1995 transmission is hydraulic. So yeah it will fit no it will not work with out doing other work. Also The speed sensor is cable in the 1991 and the 1992-1995 is electronic,.....so more work.
how to replace the thermal switch relay on a 1992 Honda civic lx
no their 2 diffrent body styles
nope, different body style/generation...
The top speed for a Honda Civic del sol is 125 miles per hour. These cars were in production from 1992 to 1998. They have either a 4 speed or 5 speed transmission.
The radio codes for a 1992 Honda Civic can be found in any Honda dealership. Each code varies according to each individual car.
The speed sensor is found on the transmission of the 1992 Honda Civic. To replace the unit locate the mounting bolts and remove them. Unplug the wiring clip and pull the sensor off.
No. For the most part, Civic and Accord parts are not interchangeable.
You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.
The 1992-1995 Honda Civic LX Sedan has a 102 horsepower 16 valve engine called the D1587.
The exact oil capacity for a 1992-1995 Honda Civic DX/LX is 3.7 quarts.
Click on the related link for all questions and answers about Honda Civic.
Yes. If it has the same type of motor as from the car you got the transmission from.
Why do you want to put an OBD0 distributor in a OBD1 motor?
as long as there has been no engine swapping going on, yes
No, they have different motors, so the tranny's will not interchange.