They are adjusted with shims. Unless you have a supply of shims, this job is best left to a professional.
this is wrong you can adjust the valve lash with a feel gauge intake is .018 to .022
the exhaust is .023 to .027 all in mm make sure the car is cold when you adjust the setting on the valve lash. the order to adjust the valve is when it is at rest
The valve adjustment specs on a 1993 Accord are as follows Intake-0.0008 to 0.0018 inch Exhaust-0.0022 to 0.0031 inch these specs are for the 1993 Accord ONLY!! if you have a 1990-1992 these specifications change.
The Valve clearance for a 1993 TRX Honda Fourtrax is 0.03 on a feeler gauge. 0.03 -intake 0.03-exhaust
Replace the PCV Valve.
You pour into the valve cover.
There is no adjustment.
Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.
Ok, you have a 1993 Honda Accord. Have a question.
my 1993 accord doesnt have spark
A Freon system on a 1993 Honda Accord uses a valve on the A/C hardline where a user can connect a A/C refill can. Following directions on the refill bottle will show how much Freon is needed to pressurize the system.
1993 honda accord is obd1 not obd2
The idle adjustment screw of the idle control valve is what needs adjusting. Either opening or closing the valve moves the throttle plate and adjusts the idle.
On a 90-93 Honda Accord you can adjust the idle with a screwdriver. On the throttle body there is a screw on the top left above the intake duct. Just adjust until idle is in correct range (usually around 700)
The 1993 oxygen sensor is the best sensor for a 1993 Honda Accord EX.
there is no transmission pan on the 1993 accord it has a sealed case
can someone help me i need to know how to set the timer on a 1993 Honda accord
To adjust the idle speed on a 1993 Honda Accord, you will need to locate the adjustment screw which is located on the throttle body. This can stick at times due to obstructions. Once the screw is located, apply carb cleaner to loosen up any debris which may be causing the idle speed to be off.
1) Unplug the electrical connector for the EGR valve lift sensor. 2) Remove the two nuts that secure the EGR valve and detach the valve. 3) Clean the mating surfaces of the EGR valve and adapter. 4) Install the EGR valve using a new gasket. Tighten the nuts securely. 5) Plug in the electrical connector. These instructions come from the Haynes repair manual for Honda Accord 1990-1993 which also has good illustrations.
its the valve on the right side. mounted on the intake manifold. if u remove it and clean it realy good, you can re-use it and it will fix the irratic high/low idle.
adjust your lifters and valves under your valve covers to spec. look in your heyens manuel.
A 1993 Honda Accord automatic transmission requires 2.5 quarts of fluid.
On the valve cover
The 1993 Honda accord, I believe, does NOT have CD Player. It only have cassette and radio player.