Wouldn't it be as simple as putting an RC filter on the select line?
The injection rate is the number of injections. The injection pressure is the pressure the injection is under.
It is responsible for material charging and injection. It helps inject the material into the mould.
This could be a lot of things. It is hard to say for sure with out seeing your car. 1. It could be that one of the plug wires is damaged. 2. Bad O2 sensor. 3. Could be that your fuel injectors need to be cleaned. 4. If you have an older car that has a throttle body injection system or a carburator, you will have a distributer cap. If there is moisture in it, your car will run this way. However, the moisture usually will evaporate and the problem will go away. This is probably not your problem. I would think that this probably has something to do with fuel getting to the fuel injector system or something else in the fuel system. I have had all of the above problems, so I know that these things could be your problem. The easiest thing to do to find out where the problem lies is to go to an automotive store and ask them to do a computer diagnostics on your car. A lot of stores offer this service free of charge. A mechanic will charge you for this service. A diagnostic will tell you where the problem lies.
it is injection moulded
Expain 3 shot injection molding process
to make easier, to get rid of, to lessen; /to alleviate pain or sorrow/ To get rid of. Eliminate is a good synonym. to remove or to reduce. as in to alleviate pressure from something to make easier to endure; lessen; mitigate: to alleviate sorrow; to alleviate pain. to make easier to endure; lessen; mitigate: to alleviate sorrow; to alleviate pain.
The spelling is the same as the US: alleviate (reduce a problem)
Problem focused coping
I don't think that it is possible
The medication did not alleviate the symptoms she was having. The kind man at the funeral tried to alleviate the grief of the mourners. There is no known medication to alleviate the suffering of all mankind.
You can get injections to alleviate the pain. Two types are Facet injection and Epidural steroid injection. It is not necessary but surgery is an option too. Most common surgery is a decompression with a fusion.
Direct injection injects the fuel charge directly into the combustion chamber, (more efficient). Indirect injection injects the fuel charge into the intake port behind the intake valve, or in the case of Throttle Body injection, into the center of the intake manifold for distribution to the cylinders. Indirect injection was much cheaper to produce, but resulted in higher emissions and reduced power relative to direct injection.Source(s):ASE Master Technician, 46 years experience.
This could be a number of problems... Fuel pump problem? Carbuerator / fuel injection problem? Timing problem?
I can only think of a steriod injection
Palliative XRT is Radiation Therapy meant to alleviate, or relieve a problem without actually curing it.
Lip injection problem
it works on the principle of direct injection system of petrol engine