0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why we pour acids in test tube along its wall?
To avoid splashing.
Why don't you heat a test tube continuously?
To avoid dangerous tension in the glass.
What is a device with two long arms hinged together used in the lab to hold a test tube or flask to avoid injury?
Tongs
Why would a reliant hot water heater not be working properly if all the elements and thermostats have been replaced?
If the dip tube (cold) side is broken or disintegrated. The dip tube is a long tube that forces cold water to the bottom of the water heater so that it keeps the hot water at the top and the cold water from mixing with the hot water. The dip tubes for most maufacturers are made by one company and are made of plastic. There was a oxidizing problem with the tubes in the late 80's and thru the 90's. Oxygen deteriorated the tubes and they disintigrated. Therefore the hot water and the cold water mixed at the top and you get only luk warm water after a short period. Also check that you have 220 volts at the thermostats on the water heater and that the circuit or circuit breaker are not broken going to the water heater.
What are the small rust particles in your water?
It's sediment from you water heater. The chlorine and other chemicals put into the water to purify it, settle in the water heater when your water isn't being used. When you use your hot water your water heater starts filling with cold water which shakes up the sediment in the bottom. when the hot water is running the loose particles can get into your hot water lines. They can pass until they hit the screens or airators in your lines causing build up. The best solution is to replace your water heater, take off all airators and shower heads clean them out and flush out the hot water system before putting them back on. White particles in water can be caused by calcium if the water is considered hard water. It can also be plastic dip tube that is inside the hot water heater. Check your water heater to see if it has a bad dip tube. The DIP TUBE is a plastic tube that sends the incoming cold water to the bottom of the tank to prevent it from mixing with the hot water going to your faucets. For a period of time between 1993 & 1997, most water heater manufacturers were supplied with defective dip tubes from the same manufacturing company. The problem caused the dip tube to disintegrate slowly, and the particles and chunks to clog up faucets, aerators, etc. There was a class action lawsuit that provided dip tube replacement for those who signed up in time, but that program is now over. Many people didn't hear about the problem in time even though the media reported it on new shows and in newspapers many times for several years.
Where can you purchase Radiant Tube heaters?
There are many retailers that offer a radiant tube heater both online and at local hardware stores. Where to purchase a radiant tube heater depends on the type of radiant tube heater that is needed and what the customer is willing to pay as prices vary greatly with type and retailer.
How does a human person reacts when food accidentally enters air tube?
they start gagging and choking
Who is Emil Daiber?
he invented the heater from the pitot tube.
How do you hook up 1968 chev C10 327 ci heater hoses?
It matters if it has ac or not. If it is a non ac vehicle, the hoses and coolant flow from the fitting close to the thermostat housing to the lower heater core tube, then out the upper heater core tube to the fitting on the water pump. If it has ac, the hose from the upper heater core tube connects to the fitting on the radiator.
What is the part number for the heater return tube O ring?
4740906
Why would coolant leak from the aircondition condensation drain tube of an E350 econoline van?
The heater core is located in the same place.If you have coolant coming from the tube,your heater core is bad and needs to be replaced.
How do you replace a heater hose on a 1965 ford mustang?
First you need to drain the coolant enough so there's no coolant in the heater lines. Then you have to go under the dash and open up the heater plenum (the black box) and disconnect whatever heater tube you are replacing form the heater core. Lastly, remove the other end of the heater tube from the water pump/intake and pull it through the firewall. Install is the same but in reverse.
How do you bypass the Heater Core in 1995 Chevy Blazer?
Just unhook the hoses from the heater core and put a tube are something in the middle of them and clamp them together.
Why we pour acids in test tube along its wall?
To avoid splashing.
Where is the air heater intake on 98 dodge diesel?
It is between the air tube and the cylinder head.
Is mercury in any devices always in a capillary tube?
A thermometer has a capillary tube but a mercury switch in a heater thermostat has mercury that just rolls back and forth.
Heat exchangers can be found in what systems?
furnance Applications of finned tube heat exchangers embody Steam air heater / steam radiator, energy fluid air heater / energy fluid radiator, predicament air heater / predicament radiator, Air heater for spray dryers, Air heater for fluid bed dryer, Air heater for flash dryers and Air heater for dryers. These area unit factory-made exploitation high grade steel, stainless-steel, copper, brass and metal. Our Finned Tube Heat exchangers area unit designed to satisfy the particular temperature, heavy duty condition and pressure of the fluids. Fin tubes,tubos aletados, acero inoxidable, Stainless Steel 304, Aluminum,Finned tube,Brass tube, Valve & Pipe Fitting Supplier at http://www.ts-aceroinoxidable.com
