0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you put brake drum back on after replacing brake shoe hard getting back on?
Back off the self adjuster and the e-brake adjustment.
What is a self-adjusting brake kit?
The self adjuster brake kit is replacement hardware for the adjuster for the brake shoes. If there is a problem with the adjuster it might allow the brakes to back off causing a brake failure. If you are changing this yourself be aware there is a left and right side, if these are mixed up or not installed correctly you will have a brake failure. Best to leave it to a qualified mechanic.
Where is the rear brake adjuster on a 2000 Mazda 626?
The 2000 Mazda 626 rear brake adjuster is located on the and of the brake pad. The brake adjuster is a screw. Your brakes should automatically adjust every time you back up and apply the brake.
How do you adjust front brakes on a Honda trx450?
Raise the front wheels off of the ground, remove the red rubber plug on the hub, turn the wheel until you see an adjuster wheel (there will one for each brake shoe, two per wheel), turn the adjuster wheel with a small pry bar in the direction of the arrow next to it, the adjuster will stop turning when the brake shoe contacts the drum, back off the adjuster 2 clicks and continue to the next adjuster.
How do you remove brake drums?
Make sure the parking brake is off. Jack up the car. Take the tire off. If there is a nut, remove it. Then the drum should slide right off. You may have to spray with a rust penetrate, and hit with a hammer to brake it free. You may also have to back the adjuster off.
How do you put the rear brake drum back on?
Make sure that the brake adjuster is screwed in to the minimum setting. the drum will be tight but should slide on. The adjuster can be extended with a brake tool or screwdriver through the hole in the backer plate.
How do you change the handbrake cable for a cavalier rear section?
Remove wheel Back off on Emeergency brake adjuster all the way and diconnect Compress or break off holding tabs on the brake backing plate Release cable from holder on brake shoe or caliper and remove
How do you replace the front brake drums for a 1965 mustang?
After jacking the car up and removing the front tires, remove the wheel-bearing dust cap, remove cotter pin, then remove nut, turning it counter-clockwise, then remove the large washer. Now, tap the top of the brake drum with the palm of your hand, and the front bearing should pop out. Then slide the brake drum off. If the brake drum does not come off, you will have to turn the brake shoe adjuster inward. The brake shoe adjuster is located in the slot in the back near the bottom ball joint. Pull brake drum off.
Where rear brake adjuster on 92 Pontiac Bonneville?
Drum brake I assume, the adjuster is located at the six o'clock position of the assembly when you get the drum off. The adjuster mechanisms seize up and fail after a decade or two, so get a kit for the brakes with springs and all, you won't regret it.
How do you remove the rear drum on a 93 mercury villager?
The drum should come off as soon as the wheel is removed. There is nothing holding the drum in place except the wheel. If it seems stuck the brake shoes have probably worn a groove into it, and you may have to back off the brake adjuster to get it off.
Do you have to remove the parking brake to get the rear rotor off on a 2003 dodge ram 1500?
You may have to loosen the parking brake shoe adjuster.
New drums wont go over new shoes with the adjuster in with out adjuster slides on fine adjuster is screwed all the way in on 1992 Chevy Blazer S10 any tips?
Be sure the e-brake cables are free and the e-brake cable adjustment is backed off.
