You don't. you remove the large lock ring around the filter housing, separate the top from the bottom. Lift out the filter element. Hose it off. Clean out the bottom of the tank. Put filter back in tank. Put lock ring back on the filter and tighten it unitil it Locks. Done.
No you only backwash your pool when your filter pressure on your filter is high 30psi and above on most pools. If you backwash your pool be sure to add two scoops of de to your skimmer. If the presure is still high the u need to clean the filter
Backwashing is done to clean the filter media in sand and DE systems. Cartridge filter systems don't have a "backwash" provision. You just remove the cartridges and wash off the dirt and debris with a hose.
"BACKWASH" THEN RINSE THEN FILTER.K
That would depend on the filter . the best thing to do would be to contact the manufacturer of the filter.
No , if you have a D.E. filter instead of an older cartridge filter than the D.E. can get pretty messy if when you filter clean , and if you have a backwash when you backwash .
Yes. It is important because grids inside will not get clogged by dirt, dust and other elements getting into pool and will not brake that easily. Also pool water will look better and you will have easier filter cleaning next time. Add some D.E. after backwash, too.
how do i calculate the volumn of backwash in a pool
It sounds like either your valve is not set completely to "filter" or your valve's seals are degrading. If the valve is completely set to "filter", then either replace the valve, or plug the end of the backwash hose.Here's a good place to look for new backwash filters: http://www.swiftpoolsupplies.com/category/product-list/backwash-valves
You add D.E. to a pool when you do a fresh filter clean. You also add D.E. if you have to backwash your pool more than normal. When you backwash the pool it is also dumping the D.E. out so it needs to be replaced to keep the grids covered so the pool can filter properly. Hope it helped
The "backwash knob" - usually called the handle - is located on top of the filter or just to the side of the filter on a sand filter. They could be on the very bottom of the filter or to one side of the filter but never on the pump. The filter is the large tank.
Take the cartridge out and hose it off
Filter, winter, closed, backwash, rinse, waste