Want this question answered?
To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.
Start by taking the top off of the coolant overflow reservoir. To bleed the system, run the 1998 VW 2.0 Beetle about 10 minutes, then check the coolant level. Add coolant if needed, then replace the reservoir top.
There is only valve to bleed coolant and not air. If you want to bleed air of the system, you need to park the car on incline of 10-15 degrees (front ahead) and run the engine for some time. It will work out all air.
did u bleed the coolant system of air cuz that could be the reason
low engine coolant level, your heater core is at the very top, so if its not full to the very top it wont work. add coolant and bleed system.
You have to drain the system via the bleed screws on the calipers. Then, after refilling the system with fresh fluid, you need to bleed the system to remove any air.
have coolant system pressure tested and look for the leaks
Just drained my coolant on a 1998 and had a hard time getting air out. I ended up filling degass tank almost to top idling engine for a short time . Then let engine cool and add more coolant had to repeat this procedure several times before heater would continue to blow warm air. Jeff
It is important to have diagrams of a car when making changes to it. A diagram of a 1998 Toyota Celica engine can be found in its maintenance manual.
the system is probably out of coolant.
If you look hard enought there is a way to bleed the clutch but its a whole process....,they come pre bleed from the factory so theres no manufacture instructions
To repair the 1998 Cadillac Catera coolant system, the steps will vary depending on the actual problem. You might need to replace hoses or connections or you might need a new radiator or thermostat.?æ