there are two places to blead your clutch and its a two person job the first thing you do is fill the clutch master cly. theres a bleeder screw on it then refill the cly. and bleed it at the slave cly. this is all done the same way you bleed your brake system
It is made on to the clutch slave cylinder that mounts on the side of the transmission.
Yes
No they will not.
depending on model of truck.
Diagram of 1990 chevy truck steering column
yes, they should be identical.
Yes it will.
if its hydraulic there could be air in your line. bleed your clutch and refill.
That would be the 700R4
Which engine?
Yes it is most likely the clutch release bearing and i would say 400 to 600 is about normal for clutch replacement.
NO. It has a cable.