Try squeezing the upper radiator hose VERY HARD and VERY FAST with BOTH hands. Repeatedly. This will often force coolant into the engine and result in forcing air out.
procedure on how to bleed air out of coolant system on 97 saturn ls
The Villager engine does not have a coolant bleed valve.
how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
there isn't one.
It is in the bottom of the coolant surge Tank. That is beside the air filter box.
The thermostat should have a air bleed valve built in and the air bleed valve should be facing straight up.
There is no reason to bleed the air from the fuel lines on a fuel injected engine, It will bleed itself through the injectors when you are trying to start it.
Is the question how to bleed a Buick 3800 cooling system? I would say open that little petcock by the themostat housing and release all the air as you fill the system with coolant. When coolant comes out instead of air all the air is out.
Good luck haha..
To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.