How do you bleed the brakes in a 2000 Toyota Camry?

Answer 1

Bleed in this sequence. RR-LR-RF-LF If you don't know how to blled brakes, then read this. http://www.stoptech.com/tech_info/wp_howto_bleedbrakes.shtml Two people needed.One gets under car with 10mm wrench ,safety raised up,the other in drivers seat. Driver pumps pedal 5 times and HOLDS IT to the floor, wrench opens bleeder, fluid and air come out,wrench tightens bleeder and yells to driver,"pump up pedal 5 times and hold it", does so, wrench again opens bleeder and out comes air/ fluid. NEVER HAVE BLEEDER OPEN WHEN PEDAL IS BEING PUMPED OR TONS OF AIR WILL GET IN !!!NOW add more fluid to master cylinder... Make sure you don't run it too low. After adding fluid, you start again; 3 times per wheel should do it. Top off fluid after all are completed. Done. Good luck.