Best Answer

Ok the easiest way to do this it to find the clutch slave cylinder, look for a release bolt or something that looks like a grease fitting, have a friend fill the clutch slave resovior with brake fluid, and losten the release bolt tell them to pump 3 times and thenhold until you see fluid shoot out then close it, repeat the process, until there is no air in the lines.

User Avatar

Wiki User

โˆ™ 2011-09-12 23:37:08
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you bleed the clutch in a 98 Mitsubishi Eclipse?
Write your answer...
Still have questions?
magnify glass
Related questions

Is the 98 Mitsubishi eclipse gs spyder turbo charged?

No. The gs is the base eclipse spyder model.

Is it possible to take the engine from a 1998 Mitsubishi eclipse spyder GS and put it in a 96 eclipse rs?

No the engine in the 98 mitsubishi eclipse spyder gs is a mitsubishi 4g64 while the engine in the 96 rs is a chrysler 420a engine.

What engine can i swap with my 98 Mitsubishi eclipse gs fwd?

You can try the EDZ 2.4l

Where can I get the ignition diagram instalation for a 1997 Mitsubishi eclipse spyder?

How do you remove an instrument panel on a 98 Mitsubishi eclipse?

To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.

Will a turbo manifold from a 98 Mitsubishi eclipse gst fit on the gs engine 420a?

no, the heads are different.

Are 98 and 99 mitsubishi eclipse transmission shift computer the same?

If they are the same model (RS, GS etc).

Can you take a 94 5 speed auto Camaro transmission and put it in a 98 Mitsubishi Eclipse?

yes u can

Does a 98 Mitsubishi Eclipse have voltage regulator?

well it would most likely be in the alternator as with most other cars

Where can you find good tech information for a Mitsu Eclipse?

buy this book.

How do you disable the anti theft system on a 98 Mitsubishi Eclipse GS?

To disable the anti-theft system on a 98 Mitsubishi Eclipse GS by locking and unlocking the driver's side door. You can also put the key in the ignition and turn it halfway. Leave it in the position for 10 minutes and start the car.

Where is the data line connector on a 98 Mitsubishi eclipse gst?

under the driver side dash next to the center console.

People also asked