0
Fill your slave cylinder using a hypodermic syringe (won't take much) and install it. Before you tighten the connection to the slave cylinder, bleed the air out of the line by filling the reservoir and pumping the air out until it runs clear. After it runs clear, tighten the connection to the slave cylinder.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you bleed the clutch on a 1993 Mazda B2200?
follow the line from the master cylinder for the clutch usually there is a bleeder screw on the fire wall a couple feet from cyclinder, get some one to pump the clutch as you would bleeding the brakes, then theres a nother bleeder screw b4 the line goes to the flexline by the trans
How do you bleed the clutch line on a 2004 Ford F-250 with no bleed screw on either cylinder?
There wont be one on the master but there is one on the slave, it looks like a grease fitting.
How do you bleed the Mercedes c180 clutch?
You can bleed the clutch by loosening the fluid line. With the line loose pump the brakes until fluid comes out.
How do you bleed the clutch line on a 2004 ford ranger edge?
how do I bleed the clutch system in a 2004 ford ranger
How do you bleed the clutch on a 2000 Toyota Tacoma 4x4?
the best way to "bleed" any clutch is to get a can with a pump and a hose that will fit over the bleed screw. Loosen the bleed screw put the hose over it and pump fluid back up to the master cylinder this will force any air out.
How do you bleed a f250 hydraulic clutch?
you bleed it just like you would blled your brakes 2 people one pumps then hold clutch the other opens bleed screw on slave cylinder till you get stream of fluid no air about 2 times then refill master cylinder but there is no bleeder screw on clutch
How do you bleed a clutch on a 1993 Honda Civic?
Pump the pedal to the floor and then screw on the cylinder.
Where is the bleed screw located for the clutch on an SC2 coupe?
From what I have heard you cannot bleed the clutch in a Saturn because it is all one peice. this was form a Saturn mechanic. hope it helps.
How do you bleed the master clutch cylinder on a 95 fire-bird?
Fill resevoir Open bleeder screw to let fluid run out depress clutch pedal to floor Close bleeder screw
How do you bleed a slave cylinder on a 95 camaro with no bleed valve?
There is no bleed screw on the 3.4 clutch. You have to unbolt the slave cylinder from the trans and drop it down so that it and the line are lower than the master cylinder, then pump the piston in/out to force any trapped air up to the master cylinder.
How do you bleed a clutch in a 1990 Chevy truck 350?
there are two places to blead your clutch and its a two person job the first thing you do is fill the clutch master cly. theres a bleeder screw on it then refill the cly. and bleed it at the slave cly. this is all done the same way you bleed your brake system
How do you bleed the air in your clutch line on a 1997 gmc sonoma?
same as bleeding the air in the clutch line for any other car -stab the air.
