Best Answer

One way is to let the car idle with the reservoir cap off, called "burping" should get rid of most air pockets in the engine.

User Avatar

Wiki User

โˆ™ 2018-04-28 19:27:13
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you bleed the coolant system of a 1995 Chevy Cavalier?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you bleed air out of coolant system 97 Saturn?

procedure on how to bleed air out of coolant system on 97 saturn ls

Is there a coolant bleed valve on a Chevy s10 4.3L v6?


How do you bleed your V6 coolant system?

how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......

Where is the place you bleed coolant system?

It is not necessary to bleed the coolant system. If you mean "drain" the system, there is usually a plastic plug on the radiator or, you can pull the lower radiator hose off.

I am Trying to bleed air out of a 2000 Chevy impala radiator?

This should happen automatically. Are you losing coolant, is the cooling system leaking somewhere? Have you just changed the coolant? Unless there is a leak, the system should purge by itself.

How do you bleed the coolant system on a 2004 Chevrolet express 3500 van?

You have to use a radiator funnel kit from napa part # 77-4000 runs about $20. Chevy vans do not have a bleed screw.

Do you have to bleed the cooling system after changing the thermostat on a 1996 Chevy Cavalier and if so how?

I would. Just remove radiator cap and start the engine and let it run for 30 minutes. As it runs, the stat will open and coolant will circulate pushing the air out. You will need to watch it and top off the coolant. After 30 minutes of cycling this will be done.

How Do you Bleed The Coolant System On A 1998 Beetle?

To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.

1998 Chevy Monte Carlo as of lately the low coolant light will come on and there is antifreeze in radiator and the resevoire has up to the line what can the problem be?

did u bleed the coolant system of air cuz that could be the reason

How do you bleed the coolant system on a 2002 impala?

There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.

How do you bleed the coolant system on a 1996 Chevy cavalier?

There is a thermostat bypass hose that is metal and has a hex screw mounted atop it. Open this slowly with light pressure to not put serious torque or you will break it off. Then allow the system to vent until a steady stream of coolant emerges. Once the steady stream emerges, slowly and with as little pressure as possible tighten the hex screw DO NOT SNAP OFF THE HEAD, until coolant discontinues from the valve.

How do you bleed coolant system after replacing thermostat?

what is the year make & modle of it??

People also asked