How do you bleed the hydraulic clutch on a 96 Kia Sephia?

Answer 1

There is a bleeder nut/valve (8mm) on the master slave which is located on the front of the transmission you'll need 2 people have some one press all the way down on the clutch and have the other person open and close the valve and keep doing it only keep the valve open for a second though until all the air is out but keep watching the fluid reservoir and keep it above "Min" on it bleed all the air out then tighten up the valve fairly snug and your set

Answer 2

The alternator is located behind the head of the engine on the passenger side of the vehicle. There are 3 bolts that will have to be loosen or removed so the alternator can be removed too. Also the electrical wires will need to be removed. There should be at least 2 of them. One snaps or pulls off and the other can be loosen with a 10 mm wrench of socket. You'll need a 12 mm socket or wrench and a 14 mm wrench or socket to get to the bolts. Once that is acquired, the alternator should come right off. You'll need to go under the vehicle to gain access to the bottom bolt of the alternator. Replace the new one in reverse order.

Answer 3

Find the clutch fluid oil reservoir and take the capÊoff. Lift the clutch pedal towards the car seat. Locate the stop-nut on the clutch arm and loosen it. Position the pedal and and tighten the nut. Test the clutch.

Answer 4

To replace a starter on a 98 Kia Sephia, turn off the ignition and disconnect the negative and positive battery cables.ÊDisconnect all the bolts that hold the starter to the block and replace with new.Ê

Answer 5

Go to Streetkiaz.com and sign up !!Look in the how to forums for your answer

Answer 6

They are located beneath a cover on the top of the engine. The cover contains letters and numbers of the engine marker.