Use a straight edged screwdriver. Put the edge about 1/4 of an inch intothe lock and turn it If its a cheapy Chinese scooter like mine it will easily pop open
You don't.
Bicycle, scooter, motor cycle has a seat, but they can not seat on him self. And they always run not walk.
If it is under 50cc, has lights and such, and has a seat height of 25", then no. Over 50cc and is must have a title and you have to have a motorcycle license and insurance.
Why will my abs break light and seat belt light stay lite on the dash of a 2003 chevy Tahoe while the motor is running? Please help. Thank you.
No you cannot. The motor will not bolt up the same to the body. I tried using a motor from a four door into a two door and did not work. Those seat belts are just a big pain in the butt anyways. When I locked both of mine on my 95 LX Sport I left them alone.
most scooters it is under the seat compartment
SEAT HEIGHT OF 32 INCHES.
On mos paper. Also on the VIN plate, on the right side, under the seat, forward next to the motor/air filter cover. Also appears on the CARB/EPA emissions data plate, left side, above the footrest.
A scooter is 2 wheel vehicle(a vehicle is something that moves you) that has a handle bar connected to the front wheel that allows you to steer it. It doesn't have pedals and is ridden while standing up. It can have a seat but if you have to be sitting down to be using it safely or properly, then it is NOT scooter as a scooter should be able to be used without the seat just fine. Ff you need the seat, then it is known as a 2wheel cycle or a pedless bicycle.THose are the characteristics that define a Scooter. 100cc scooters and bigger engine sized scooters aren't actually scooters because you need the seat to use it properly.-Anthony V
most are on a plate in the seat compartment.
You can not take of the seat. The seat belongs in the car!!! I donot even know why you would even think about taking the seat out!! You are so silly!!!
It is located underneath the seat.
Hydraulic Pump AssemblyREMOVAL# Disconnect battery negative cable. # Remove rear seat cushion and rear seat back. # Disconnect pump wire connector and ground connection. # Disconnect hydraulic lines from pump. # Remove motor pump assembly from vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up on motor assembly to remove.