4cx95mm aws which size of cable gland
cable gland sise 20s means
Yes I could. How?
To calculate voltage drop to size the wire, a voltage must be stated.
Cable size is determined by current. You did not provide the current, nor did you include the voltage so that we could calculate the current. Please restate the question, and include either the current or the voltage.
The size of a cable needed for 3.5KW shower can range from 4.0mm.
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
cable gland sise 20s means
32L
A cable gland is a connector which holds the end of a cable in place.
The NEC has a table that shows what size cable to use with each amperage and where it can be used.
How to calculate a cable size of 3kw motor
Yes I could. How?
You need to know the amperage requirement of the pump and then you can calculate the wire size.
100 kw is the power drawn by the load. to calculate the cable size you need to know the voltage. From that you can calculate the current. this decides the cable size. for example if the voltage is 400Volts then the current flowing in the circuit when the load is 100 KW will be 250 amps. (100,000/400). for 250 amps to flow with out causing excessive heating of the cable the cross sectional area of the copper cable should be 150 sq mm.for a round cross section the diameter will be roughly 15mm.
Due to the induced voltage in the cable gland by the current flowing through the conductors enclosed by the armour.
To calculate voltage drop to size the wire, a voltage must be stated.
to calculate the cable size of a run of 30 meters long you first will have to know the current of the appliance use the voltage drop formula V d = (mVxIxL)/1000 once the voltage drop is less than 2.5% of the nominal voltage, the cable should be upsize.