Want this question answered?
when i calibrate my FMC wheel balancer i only get cal o not cal good at the end
http://www.agequipment.co.uk/fmccal.html
Is made by snap on and is usually a john bean balancer with FMC name on it
You can get your FMC/John Bean 2500/4100 or 5800 repaired @ ADER inc.
there, thanks for answering. Can you get me a copy of the user manual please? Gretings Ad LBS
Operators Manual: http://www.snaponequipment.com/common/op-manuals/jb/past-products/4100_om.pdf
http://www.snaponequipment.com/common/op-manuals/jb/past-products/4100_om.pdf
http://www.agequipment.co.uk/fmccal.html
Install the calibration slug on the lip of the backing plate Press the F key Press the 1 key lower wheel guard pres spin key display reads CAL SLU should spin for about 30 seconds display reads CAL 0 Remove calibration slug lower guard and spin Display should read CAL GOOD
Mine is doing the same thing playa did you figure out a fix?
Directly, it means one of the force sensors is reading low. I think the left one. But, on my 4100 balancer, i had an issue with the angular position sensor (the encoder wheel) which for some reason gave me the same error.
As of July 2014, the market cap for FMC Corporation (FMC) is $9,118,969,438.08.