if you meant a cylinder rod then you must take off the oil pan gasket and remove the oil connecting rod cap bearings to the cylinder rod- they cylinder must be removed from the top of the engine- to do this you must remove the cylinder head- you must use a ridge reamer to clean the ridge then remove the cylinder and rod from the engine - there is usually a reason the rod is bad- check bottom pan for damage to the bearings and check the cylinder for scoring or damamge- replace any bearings or connecting rods that are out of spec by using a plasigate you can check lower bearings and cap bearings check specs on piston rings and cylinder walls
how to change upper tie rod on 96 chevy blazer
A bent engine piston is a reference to the piston rod. The piston cannot be bent, but the piston rod can be bent.
Sure can, Quick A bent push rod will cause a loose rocker A loose rocker has no way to bend a push rod, there is no pressure.
Bent crank or bent connecting rod. Probably bent connecting rod...
Replace push-rod
Remove the valve cover. Remove the center nut or bolt that holds down the rocker arm. remove rocker arm, pull out the bent push rod. Install new push rod and put it back together.
Which ever one you think may be bent, Just take it out and roll it on a flat surface. If it is bent bad you will have a engine miss on that cylinder.
It depends on the precise material and the dimensions of the rod
It will have to be replaced. Even bent back to shape with the fatigue would no longer be safe.
becaus eit likes chicken
STIRRUPS
Hot Rod Circuit was created in 1997.