0
You need to remove the Distributor Cap and then the rotor The CPS sits right underneither the distributor cap and is held in place by the caps mounting screws.
When the cap and rotor are removed, the CPS will lift right up. you then just need to unplug it from the connector on the drivers side of the engine. The CPS assembly looks like a flat circle with a wire hangin off of it and a hole in the middle.
Putting it back is just as simple, just make sure to note the position of cynlinder 1 on the cap, because the Sensor assembly must line up the same way as well. It will have a mark for cylinder 1 as well.
If you are looking to buy one, the stores list them as a Ignition pickup or pickup coil?
Might as well replace hte cap and rotor at this time too. The job is in a tight space, but if you remove the aif filter assembly, you will have enough room.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
2006 dodge durango camshaft position sensor location?
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
Where is the camshaft position sensor located on a 2006 dodge stratus?
Where is a camshaft position senser located on a 2006 dodge durango/
Where is the camshaft position sensor in a 95 dodge 2500 3.9?
The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.
Where is the camshaft position sensor on a 2001 5.2 Dodge Ram sport?
The camshaft position sensor on a 2001 Dodge Ram 5.2 is inside the distributor, under the rotor.
What does code P0340 mean on a 1999 Dodge Durango?
Camshaft position sensor circuit malfunction.Camshaft position sensor circuit malfunction.
What does code P0344 mean on a dodge 97 caravan 2.4?
P0344 Camshaft Position Sensor Circuit IntermittentP0344 Camshaft Position Sensor Circuit Intermittent
Where is the camshaft sensor located on a 2006 dodge stratus?
Where is a camshaft position senser located on a 2006 Dodge durango/
Where is the camshaft position sensor on a dodge ram 2500 5.7?
The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.
What is cmp or ckp on an 2000 Dodge Intrepid?
CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.
Where is the Camshaft position sensor located on a 1988 dodge Dakota?
It is in the distributor.
Where is the camshaft position sensor on a 1998 Dodge truck?
It is inside the distributor.
Where is the camshaft position sensor on a 2002 dodge stratus?
Above the timming cover
