0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the camshaft sensor on vectra c?
diagram of where crank shaft sensor goes on vauxhall vectra 2.o sri 1999 model
Where is the camshaft sensor on a vectra 1.9 diesel z19dt?
Behind the camshaft vernier wheel on the Z19DT 120 engine
Where is the camshaft sensor on a vectra b?
Open your bonnet look where the ecotec cover is to the left of that there will be a wire that goes in a gap that's 4 your cam sensor
What mileage should you change a cambelt on a Holden Vectra 2.5v6?
60, 000 kms
Your 2000 vectra cuts out at 70mph the engine management light comes on and either get full or no power at this point any ideas?
Camshaft Sensor fault... goes in to limp mode won't rev more than 4,5000 rpm Change sensor but make sur it is a genuine Seimans sensor
How do you change vectra camshaft?
can u get a bushing for ur cam shaft pulley ? or do ya buy ful thing
Where is the engine number for a 1997 Holden vectra?
The engine number for a 1997 Holden Vectra is on top of the engine itself. it is engraved into the metal of the engine.
How do you remove the alternator from a vectra 2.5 v6?
how do you remove alternator on v6 holden vectra
What engine is in the Holden vectra?
The engine in the Holden Vectra is 3.2L V6 engine. The engine has a fuel capacity of 2.2 liters and others have a capacity of 3.2 liters.
Where can you find a fuse panel diagram for Holden vectra 1997 2.0litre?
Not sure exactly but might be easier searching internet for vauxhall vectra or opel vectra, tends to be easier to find information using those searches rather then Holden.. They are the exact same car but Holden just purchased the design..
How can you undo the dashboard of holden vectra 2.2?
use explosives
Are all camshaft sensors the same for all vectras mine is aTreg and i have one from an older vectra can you fit the sensor to a ecotec?
I don't know the answer to this,but would suspect they change as the engines are developed.Suggest you have a look on the sensors you have for a manufacturers part number,if they match you should be ok.
